Audison bit Ten D Guide d'installation télécharger pdf (Page 44)

ADVANCED MANUAL / bit Ten D /

If, when launching the bit Ten D PC software the “bit Ten D Warning”

window appears, you can choose between the following two ways to

proceed:

A - Use a previous version of the PC software.

E.g. if you are using PC software v.1.0, open v.0.9;

B - Update the bit Ten D firmware. In this case you will have to

proceed as follows:

- Save the previous setup (in case you want to open it

in OFFLINE mode);

- Unplug the bit Ten D from the amplifiers;

- Turn the bit Ten D off, disconnect the power supply;

- Set the UPGRADE MODE to ON (see 4.5.6);

- Reconnect the power supply and turn the bit Ten D on;

- Restart the bit Ten D PC software and select RESCUE MODE.

- The screenshot on the right shows the Boot Loader version

currently installed on the processor, which allows you to access

the menu for the update.

- Proceed as detailed in 9.3.1

9.4 RESCUE MODE

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50

Pas de commentaire

Audison bit Ten D Guide d'installation Page 44